Comments on: South Shore Furniture, Sand Castle Collection, 4 Drawer Chest, Pure White http://www.rattlecan.net/south-shore-furniture-sand-castle-collection-4-drawer-chest-pure-white/ Sat, 11 Dec 2010 17:08:03 +0000 hourly 1 http://wordpress.org/?v=3.1.2 By: MrsShopper http://www.rattlecan.net/south-shore-furniture-sand-castle-collection-4-drawer-chest-pure-white/comment-page-1/#comment-1565 MrsShopper Thu, 04 Mar 2010 14:45:50 +0000 http://www.rattlecan.net/south-shore-furniture-sand-castle-collection-4-drawer-chest-pure-white/#comment-1565 My daughter wanted a white dresser for her room at college. I purchased this one because she liked the looks of it and the price was great. OMGsh! We got to the drawers (8 sides) and there were NO pre-drilled holes to screw a flat machine screw into to hold the drawer slide in place!! We finally took all 8 sides with the hardware (which needed 2 holes each = 16 holes total) to Home Depot and they were nice enough to drill the holes. Meanwhile, one of the round feet would not hold with the screw provided (the other 3 tightened fine) and that required a trip to Ace Hardware for advice (after several attempts at plugging/wrapping the screw with tape ... to try and get it to hold). We finally figured out that that foot was pre-drilled upside down and had to screw the foot on differently than the other 3. Wasn't worth the $$ savings!! Rating: 1 / 5 My daughter wanted a white dresser for her room at college. I purchased this one because she liked the looks of it and the price was great. OMGsh! We got to the drawers (8 sides) and there were NO pre-drilled holes to screw a flat machine screw into to hold the drawer slide in place!! We finally took all 8 sides with the hardware (which needed 2 holes each = 16 holes total) to Home Depot and they were nice enough to drill the holes. Meanwhile, one of the round feet would not hold with the screw provided (the other 3 tightened fine) and that required a trip to Ace Hardware for advice (after several attempts at plugging/wrapping the screw with tape … to try and get it to hold). We finally figured out that that foot was pre-drilled upside down and had to screw the foot on differently than the other 3. Wasn’t worth the $$ savings!!
Rating: 1 / 5

]]>